Service Partner Plans

Annual Inspection – System Checks and Service

Included in all agreements

• Change oil and oil filters (materials included)
• Change fuel filters (materials included)
• Load test battery/batteries
• Check coolant level and test
• Start unit check voltage, frequency and alternator outputs
• Test low oil pressure, high temperature shut downs
• Inspection and maintenance report with any recommended repairs
• Inspect overall condition of unit
• Cooling system
• Air intake and exhaust systems
• Lube oil system
• Engine safety controls
• Control panel operations
• Operation of engine and generator
• Inspection report and repair recommendations
• Supply anti-corrosion pads as needed
• Refueling service at the request of technician

Semi-Annual Inspection – System Checks and Service

(Optional visit available – See Signature Page for Rate and Selection)

• Load test battery/batteries
• Check coolant level and test
• Start unit check voltage, frequency and alternator outputs
• Test low oil pressure, high temperature shut downs
• Inspection and maintenance report with any recommended repairs
• Inspect Overall condition of unit
• Air intake and exhaust systems
• Lube oil system
• Engine safety controls
• Control panel operations
• Operation of engine and generator
• Inspection report and repair recommendations

As appropriate, depending on the type of system in your home:

• Check for proper operation of draft inducer.
• Check thermocouple for proper operation.
• Check pilot flame for proper burning flame.
• Check blower door switch safety and furnace covers.
• Ensure all furnace covers are correctly installed.
• Check operating suction, head pressure & refrigerant charge.
• Ensure compressor starts & runs normally.
• Ensure unit water coil drainage areas & outdoor coil are clean and un-obstructed.
• Ensure changeover / heat relay cycles properly, not chattering.
• Cycle defrost controls & check operation. (If cold enough.)
• Cycle reversing valve. Check slide operation.
• Check crankcase heater, ensure it is operational.
• Check indoor air filter.
• Oil indoor blower motor.
• Check indoor blower motor V-belt, and tension.

As appropriate, depending on the type of system in your home:

• Check indoor thermostat for proper operation.
• Check for signs of poor electrical connections.
• Check indoor blower wheel for dirt and balance.
• Cycle indoor fan relay, and check for proper operation,
• Check gas valve for proper operation.
• Check and cycle fan safety and upper limit switch.
• Check flame safety limits and safety controls.
• Check control transformers output voltage and/or FLA.
• Check indoor blower motor bearings & shaft.
• Check indoor blower motor run capacitor.
• Check indoor blower motor amp draw.
• Check main burners for proper ignition and burning flame.
• Cycle & check out electronic ignition controls.
• Cycle & check combustion air / induced draft blower.

Spring Home Cooling System Inspection Checklist

• Check operating head pressure, suction pressure and superheat.
• Check condenser for coil blockage, wash out if needed.
• Check compressor starting and running amps.
• Ensure starting devices switching properly.
• Inspect accessible areas for signs of leaks and rust.
• Ensure refrigeration charge is correct.
• Check Hi & Lo pressure safety controls.
• Oil condenser fan motor. Ensure that outdoor fan blade is free of vibration and not bent.
• Check running amps & for overheating.
• Ensure all installed time delays function properly.
• Inspect compressor terminal wiring. Ensure no signs of burning, overheating, brittle insulation, or pinching.
• Inspect start and run capacitors for signs of arcing and deterioration.